Irontite ThoroFlush (468-9110-16)

Description

Irontite ThoroFlush (468-9110-16)
Product Overview
Thoro-Flush COOLANT SYSTEM FLUSH Opens and cleans out
plugged heater cores. Clears out gelled Dex-Cool with a simple flush Diesel Oil
cooler failure, cleans cooling system in a single flush Safe for use on cast
iron, aluminum, brass and plastic For improved coolant flow and temperature
control, always flush with Thoro-Flush for the best possible results Thoro-
Flush is a concentrated powder and the most powerful flush available Failed Oil
Cooler? A common failure point in high mileage medium and HD Diesel Engines is
the Oil Cooler. When this occurs, the engines coolant system becomes
contaminated by engine oil. This will turn the engine coolant into a mud-like
mixture and must be cleaned out when replacing the Oil Cooler. Solution: Two
pints of Irontite Thoro-Flush will clean and strip the oil out of the engine
cooling system with a single flush following the product instructions. Read
more Plugged Heater Core? Many of today’s vehicles are manufactured with very
tight heater cores that can become plugged over time. It is not uncommon for a
4-year-old vehicle, if the coolant system is not flushed annually and recharged
with new coolant, to simply plug. 1 symptom is no heat. Solution: One pint of
Irontite Thoro-Flush will clean, unplug and restore a heater core to a like-
new condition with a single flush following the product instructions. Read more
Dex-Cool Gelled in Coolant System Both GM and Chrysler began using Dex-Cool
extended life antifreeze in their vehicles beginning in the mid-90’s. Dex-
Cool, when mixed with non-Dex-Cool Antifreezes, will create a chemical
reaction turning the cooling system coolant into a thick gel. Symptoms will be
engine overheating and loss of heat from the vehicle’s heater. Getting this
Dex-Cool ”mud” out of a vehicle is a difficult and time consuming job. One
pint of lrontite Thoro-Flush will clean, unplug and restore a coolant system
to a like-new condition with a single simple flush. Thoro-Flush can be used
with a flushing machine or simply as a manual flush. This allows you to
recharge the system with proper coolant mixture, which will stop the vehicle
from overheating and restore the passenger heating system. Read more Clean
Fuel Tanks and Cooling Systems with Thoro-Flush Over 30% of new Fuel Pumps
fail because the installer did not clean the fuel tank properly. Fuels with
Ethanol cause a build-up of Ethanol gel in fuel tanks. Older steel tanks will
have scale and rust that can cause a new fuel pump to fail. Bio-Diesel leaves
hard-to-remove residue in the fuel tanks that cause problems throughout the
fuel system. Most fuel pump and module issues are linked to debris or
contamination in the fuel tank that may have accumulated over time, or during
the removal and replacement procedure. Fine particulate contamination can clog
the strainer causing high electrical demand on the fuel pump, and if ingested,
can result in premature wear within the pumping section. Both failure modes
result in reduced performance, premature failure, or at worst case, a walk
home. Fuel pumps and modules may be returned due to installers not cleaning
the gas tank properly, causing repair costs to skyrocket. The vehicle's
original fuel pump was installed into a clean tank, so to ensure the same
level of performance, the new pump should go into a clean tank as well. An
industry research study conducted by IMR Test Labs indicated that only 18
percent of technicians perform the fuel pump replacement procedure correctly
by thoroughly cleaning the fuel tank, fuel filler and strainer if needed. That
would indicate a full 82 percent of aftermarket fuel pumps purchased are being
installed into tanks that are potentially contaminated. One pint of lrontite
Thoro-Flush will clean and strip the Ethanol Gel, Scale, Rust, Bio Diesel
Residue along with other contaminates out of a fuel tank with a simple flush.
Follow the directions on the bottle for Fuel Tank Cleaning.
Features
Industrial Strength concentrated radiator, engine coolant system and fuel tank cleaner
Loosens and removes rust, scale, grease, oil and sludge
Cleans Auto, HD Truck and Equipment Cooling Systems
Safe for use on Cast Iron, Aluminum or Plastic
Details
Manufacturer: ‎Irontite Products Inc.
Brand: ‎Irontite
Model: ‎THORO FLUSH - 16 OZ.
Item Weight: ‎1 pounds
Product Dimensions: ‎9 x 3 x 4 inches
Item model number: ‎Thoro-Flush
Is Discontinued By Manufacturer: ‎No
Manufacturer Part Number: ‎468-9110-16
Folding: ‎No
Cover Included: ‎THORO FLUSH - 16 OZ.
Quality Products
Have peace of mind knowing that your order will arrive original factory sealed packaging. That means that you'll have the full force of the manufacturer's warranty to protect your purchase.
Fast and Free Shipping
You're already purchasing the item. Why pay additional for shipping, especially slow shipping? We get your order shipped out and delivered to your doorstep as quickly as possible.
Commitment
We are committed to making sure that you leave this transaction satisfied. That means having access to real people that get your questions and concerns answered quickly. Give us a shot and we will make sure that you will look to us again!
This listing is powered by JoeLister